Screw Blower Info/Repairs/Upgrades

 
PSICu.In/
Rev
driven rotor lobe thicknessShort ShaftLong ShaftRotors (Male) 
200C385 X Castno longer produced
200H385 X High speed/ Laminatedno longer produced
206B422.762"X High speed/ Laminatedno longer produced
   X Billetno longer produced
210C476.483" -.485" XBillet 
206D422.594" -.596"X High speed/ Laminatedno longer produced
    XHigh speed/ Laminated 
TAD - PSI "D" 422 cu.in. x 2.15 or 115% = 907.3
TAFC - PSI "D" 422 cu.in. x 2.25 or 125% = 949.6
206B case - 15.75"  length, 10.2 height, rotor 13", front shaft 3 1/8"
206D case - 17" length,  10.3 height, rotor 2", front shaft 4.5" long shaft (3 1/8 Short)
Use a 0W-20 full synthetic oil. Fill gearcase with the blower on a flat level surface until oil starts to run out the lowest ( 6 o'clock ) snout mounting hole, DO NOT use the sight-glass. The sight glass is there for oil condition / inspection ONLY.
Whipple      
 A980601     
 R980601     
 305R305     

 

Weld Replace Inlet


Note : long Double Bearing Shafts


Quick Removable inspection - Lubing top cover
Tight blowers Must be lubed every time it is started

Short Shaft Info


short shaft single bearing Case


Long shaft double bearing Case

 



and of course you can get a billet version.

PSI Delamination -
Male rotor is made from many small sheets glued together and will move if stressed enough